Onezhets 300

Request Call Back
Find Spare Parts

Advantages
Characteristics
Information materials
Characteristics

Engine
Model D-245
Rated rpm 2200
Capacity, kW/h.p. 88,2/120
Specific fuel consumption, g/kW•h 227
Transmission
Type Hydrostatic
Forward speed range, km/h 0-11,8
Rearward speed range, km/h 0-11,8
Steering mechanism Multiple disk, dry friction. Continiously closed
Service brake Two dry type tape brakes on steering mechanism drums
Parking brake Mechanical, affecting the service brakes
Final drives Double-reduction gear units with planetary final drives
Undercarriage
Drive sprockets With replaceable ring gears
No. of teeth 16
Teeth spacing, mm 150
Track width, mm 600
Maximum of the meand specific groud pressures (without load), MPa 0,03
Technological equipment hydraulic system
Pump NSh-32on engine
Maximum pressure, MPa 14
Hydraulic tank capacity, l 120
Electric equipment
Current Direct
Rated voltage, V 24
Generator With built-in voltage rectifier and voltage controller block
Accumulator battery 2×6ST-132АМ
Cab
Cab Safety frame complying with requirements of standards for FOPS, ROPS, OPS; effective, vibro, noise and heat insulation; system of microclimate normalization in winter and summer period
Seat Full-revolving, cushioned
Controls Ergonomic control board with standard values of steering effort
Machine weight, kg 11600

 

  • Onezhets 300 base machine is purposed for replacement of TLT-100A-12 base machine.  It is equipped with a new cab, enforced frame, undercarriage of higher cross-country ability with wider track chains and planetary final reduction gears with drive sprockets of bigger diameter placed closer to the bearing surface. 
  • Improvement of the undercarriage allows increasing of the length and width of the tractor bearing surface which results in rapid increase of the tractor’s cross-country ability on grounds with low bearing capacity and in deep snow, the machine’s lateral stability is also increased. Wider track chain links minimize soil disturbance. Hydrostatic transmission (HST) consists of an adjustable pump of LINDE brand, mounted on the pump drive reducing gear by Stibel, and and ajustable motor LINDE mounted on the rear axle block. Application of reinforced frame increases reliability of the machine operation. Mean time to overhaul is 10 000 machine hours. The cab features one adjustable full-revolving seat, protection, vibration and noise insulation, system of micriclimate normalization, improved observability. The machine can be equipped with engines manufactured by Russian or foreign companies.